Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly Steps
(Please refer to the actual size for accuracy.)
Decorative
cover
Chair leg
base
1
2
First, separate the base into the
Use 10 M6X14 screws to
chair leg decorative cover and
connect five chair leg tubes
the chair leg tube. Then,
to the chair base.
connect the base together.
4
5
Connect the cushion and
Connect the backrest and seat
mechanism using four M6X20
cushion using four M6X25
mechanism screws.
backrest screws, and tighten
them all to 50%.
7
8
Using two M6X40 screws to
Using four M6X25 backrest screws to
connect the armrest and backrest
connect the backrest and the seat
cushion, and using four M6X25
by screwing them together,
armrest screws to connect the armrest
ensuring they are tightened to
and seat cushion, ensuring that all
50%.
connections are tightened to 100%.
1. One chair can only bear one person's weight;
Pls read the Safety
2. Please use on the flat floor;
Instructions below
3. Not allowing the child under 5 years old to sit on the chair alone;
carefully.
4. Please don't sit on the armrest, in case cause some danger;
5. Do not stand on the chair or use it as a ladder or footsteps;
6. Please don't put overweight on the chair, or used as trolley;
7. Don't use sharp or hooked objects to scrape the chair and do not get it close to the fire;
8. For your safety, no disassembly to the gaslift is allowed.
01
Functions
3
First, insert the wheels into the
chair legs. Then, insert the
decorative cover into the chair legs.
Finally, place the gas lift into the
middle hole of the chair leg base.
Parts list
6
Connect the armrest to the seat
cushion using four M6X25 armrest
screws, and tighten them all to
50%.
9
Using two M6X40 screws to connect the
armrests to the backrest and tighten the
screws to 100%. Align the upper half of
the assembled chair with the gas lift and
insert it into place. The assembly is now
complete.
(The size will be according to regular practice.)
Push or pull the chassis
right-side lift rod to control
the tilt.
Chair height adjustment:
when seated in the chair, lift
to lower it; when not seated
in the chair, lift to raise it.
(Take the actual size as the reference;
there is one spare screw and washer for each type/model.)
Lumbar support*1
Seat cushion*1
Chair leg tube*5
Mechanism*1
Mechanism screw
Backrest screw
(M6X20)*4+1
(M6X25)*4+1
Chair leg screw
(M6X14)*10+1
Wrench*1
0
1
2
3
4
Adjust the tilt intensity of the
rotating pallet with the spring
The seat can rotate freely
in 360 degrees.
Armrest*2
Gas lift*1
Caster*5
Chair base*1
Armrest to backrest screw
Armrest to seat screw
(M6X40)*2+1
(M6X25)*4+1
Attention: Before assembling the chair,
please sort the screws properly and measure
their lengths for installation purposes.
5
6
7
8
9
10
knob.
cm
02
Werbung
