N-Gear RG500 Bedienungsanleitung Seite 6

Button Instruction:
1. Button
Single Click: Back to previous song
2. "BASS BOOST" button
Single Click: switch music mode (Bass mode/Nomal/Karaoke
3. Power on /Power off
Long press: to power on /power off the device
Single click :to pause /play music
4. Knob (Control the volume)
Rotate left to reduce the volume, rotate right to enlarge the volume
5. Charging Indicator light
It will flash when charged the speaker;light
under normal working states to display the battery capacity
6.TWS button
Single Click: Single click to enter /exit into TWS connection
1) Prepare two speaker ,single click this button for either of them,will hear a voice prompt .(PS:Pleasemake
sure the speaker is disconnected with any wireless device before using TWS function )
2)Then wait for a few seconds, will hear a voice prompt after the two speaker connected with each other
successfully. Search for the bluetooth ID to connect with bluetooth device.
3)After connected with bluetooth device, operate either speaker,the other one will be synced.
4)Single click TWS button of either of them will exit TWS mode.
Long Press:Toswitch the music playing mode
The default mode of the device is bluetooth
was inserted at the same time,long press this button each time, the playing mode will be from TF card-U
disk-AUX input , then back to bluetooth mode. There will be voice prompt when switch each mode. (Note: This
operation should be under TF card, U-disk, AUX all insert on the speaker in advance)
7.Light button
Single click:To switch the light mode
Long press: To turn on/off the light
Double click: Exit/Re-connect
8.Button "+"
Single click :Enter into next song
will be on when battery is full charged. The light will be always on
mode when turned
Bluetooth connection
mode)
on the device. When TF card, U-disk, AUX all