Before Use; Garment Steamer Assembly - Homcom Ss18 Benutzerhandbuch

Before Use

Garment steamer assembly

fig.3
fig.5
Locking the pole:
1. Adjust the pole to its maximum height by sliding it upwards
fig.6
2. Insert vertically the hanger into the hook until it is firmly
3. Place the head support/hook on the top of the pole and push
fig.7
fig.8
Pole assembly:
1. Place the base on the floor and remove the
water tank. (fig.3)
2. Unscrew the fastening lock from the base of
the steamer. (fig.4)
Insert the pole and tighten the pole's fastening
3.
lock by turning in a clockwise direction until
the fastener is securely in place. (fig.5)
then tightening up the three screws. (fig.6)
fixed. (fig.7)
down to secure. (fig.7)
Hose & Steam head assembly:
fig.9
1. Push the hose connector into the base
until resistance is felt. Lock the connector by
turning clockwise. (fig.8 & fig.9)
2. Hang the steam head on the head
support/hook. (fig.1)
fig.6
fig.4
6