RENPHO R-Q008 Bedienungsanleitung Seite 5

6. FAQ
1. How do I turn OFF the jump rope?
Leave the jump rope idle for 3mins and it will automatically enter the
standby mode and then shut down 20 seconds
2. How can I sync my skipping data to the Renpho Health App?
a. Turn on the jump rope.
b. Activate your phone's
from the jump rope. (No match code required)
c. Open the Renpho Health App and click "Pair'!
d. Once paired successfully, the data will be automatically synchronized.
Note: If bound before, you can just repeat the step. a & b to sync the data
to the Renpho Health App.
3. Can I lower the beep voice of the jump rope?
f the jump rope is connected to the app via Bluetooth, you can manually
turn OFF or ON the beep voice on the "Settings Page" of the Renpho
Health App.
4. What should I pay attention to when using the jump rope?
a. To avoid damage,
ground like concrete floors, cobblestone roads.
b. Avoid "fancy skipping" or "cross rope skipping" in case of getting
tangled or counting
5. Why is my data lost when uploading data to the app?
a. The batteries
rope is not powered
the data to the app before removing the batteries.
b. Failed to save data. To avoid data loss, press and hold the Mode Button
for 3s to save data when the Free Jump mode ends.
c. Memory exceeded.
exceeded, it will automatically cover the first data one after another.
Bluetooth
please do not use the rope on the rough or sandy
errors.
are removed or the battery
by the batteries,
Each jump rope supports
later.
and keep your phone within 1 meter
cover is loose. Once the jump
the data will be cleared.
storing
Please sync
90-100 data. Once
DE FR ES