PowerNeed S8000B Bedienungsanleitung

USER MANUAL
Thank you for purchasing the solar charger S8000B. Please read the following instructions to fully exploit the device capabilities.
General Information
Device S8000B is used for charging cell phones, tablets and other small electronic devices in accordance with the following voltage limits.
The charging process always uses the electricity stored in the battery unit. The battery can be recharged from 230V mains usingthe 5V
power adapter (not included) and built-in photovoltaic panel.
Attention
It is essential for the proper functioning of the PV panel to incident direct solar radiation on the panel. Artificial
coming from the overcast sky does not carry enough energy to generate power in the photovoltaic panel. At the same time please remember
that the angle of incidence of sunlight is highly important for the efficiency of the photovoltaic panel. For best results are achieved, when
the sun hits the panel at right angles to its surface. The above correlation is presented in the following chan.
12:00
Elements included in the kit:
• Solar Charger with battery: 8000mAh, Li-Poly
USB cable
• Extensions: mikroUSB, miniUSB, Lightning 8-pin
Technical specifications of our product:
built-in solar panel: I W
•
battery: 8000mAh (29,6 Wh), Li-P01y
built-in energy gauge
two USB ports: 5V, IA; 5V, 2A
built-in LED light
•
dimensions:
weight: 200g
•
Charging the internal battery device:
- by means of the PV panel
Place the unit in direct sunlight ensuring the right angle of the PV panel. Charging time for the ideal radiation conditions is approximately 5
7 hours for each 1000mAh capacity.
- using the AC Charger
FOR SOLAR
NW
sw
140x75x18mm
CHARGER
NE
0K
SE
S8000B
light or scattered radiation
10
20
30
40
50
60
70
80
90
C,
(70)
20
30
40
50
60
70
80
go
100