Radial Engineering POWER-1 Bedienungsanleitung Seite 4

FRONT & REAR PANEL FEATURES
6
1. FRONT PANEL OUTLETS: These outlets are always on, even when the front panel on/off switch is set to 'off'. When using
the Power-1 as a power source for equipment racks, this allows you to easily connect and charge devices without powering on the
entire rack.
2. USB CHARGING PORT: 5V/1A USB charging port for mobile devices such as smartphones and tablets. Type-C USB connection.
3. FAULT PROTECTION INDICATOR: This LED illuminates when the Power-1's Metal Oxide Varistor (MOV) is actively working,
providing fault protection against varying resistance and high-voltage spikes from the AC main power source. The MOV is designed
to recover from overvoltage events, providing continuous protection for your equipment. Should this LED turn off, immediately
remove the Power-1 from the AC main power source and contact Radial technical support for assistance.
4. ON/OFF: Large rocker switch with backlit LED activates the ten rear panel power outlets. Raised metal flanges on either side of
this control help prevent accidental switching. If the Power-1 is connected to the AC main power source and the LED for the on/off
switch doesn't illuminate, check the circuit breaker on the rear panel.
5. RACK EARS: Allow for mounting in standard 19" equipment racks, taking up 1 rack unit (1RU) of space.
6. POWER INPUT: IEC receptacle for connection to the AC main 220V power source.
7. CIRCUIT BREAKER: The Power-1 is rated for 10A of current, if this load is exceeded the circuit breaker will pop to help prevent
damage to the Power-1 and connected devices. Should the circuit breaker pop, unplug the Power-1 from the AC main power
source and press in the circuit breaker to reset it, then power back up as normal with a lower load connected to the Power-1.
8. REAR PANEL OUTLETS: Ten rear power outlets are provided, in two groups of five. These power outlets are controlled by the
front panel on/off switch.
INCLUDED POWER CORD SETS
The Power-1 220V-240V ships with three cord sets for the AC main power source, allowing it to be used in multiple regions. Always check that
the cord set is the appropriate one for your region before making connection from your main power source to the Power-1. The cable length
for each cord is approximately 2.5 meters.
United Kingdom
(Type G, BS1363A)
Radial Engineering Ltd.
1
7
Australia / New Zealand
(AS/NZ 3112)
2
3 4
8
Continental Europe
5
(CEE 7/7)
Power-1 Owner's Manual