Expondo RCKGH-01 Sicherheits- Und Betriebsanleitung Seite 15

10. Next raise the face plate, insert the shovel in the bottom of the first layer buns and take them out.
3.3. Maintenance
• Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
• Always unplug the device before cleaning it.
• Use only non-corrosive cleaners to clean the surface.
• Use only mild, food-safe detergents to wash the device.
• After cleaning the device, all parts should be dried completely before using it again.
• Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
• Do not spray the device with a water jet or submerge it in water.
• Do not allow water to get inside the device through vents in the housing of the device.
• Do not leave the battery in the device if it will not be used for a longer period of time.
• Use a soft, damp cloth for cleaning.
• Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
Disposing of used devices
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to recycle
you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
Troubleshooting
Problem
Plug was inserted, power
on, but the red indicator
does not light up.
After adjusting
temperature knob the
green indicator does not
light up.
After adjusting the
temperature knob the
green indicator lights up,
but heating plate is not
heated.
Orange indicator does not
light up and no buzzer
sound.
Alarm light indicator light
up but no buzzer sound.
The timer can't be set.
EN
Possible cause
Fault of the power cord.
Fault of the power socket.
Fault of the switch.
Fault of the temperature controller.
Fault of the heating plate.
Fault of the time controller.
Fault of the limit switch.
Fault of the buzzer.
Fault of the adjustable resistance.
Fault of the timer controller.
Solution
Check the power cord.
Check the socket; change to another if
needed.
Check the power switch, change it if
needed.
Change the temperature controller.
Check the heating and contact with
the customer care.
Check the time controller, change it if
necessary.
Check the limit switch with
mustimeter, change it if necessary.
Check the buzzer, change it if
necessary.
Check the adjustable resistance,
change it if necessary.
Check timer controller, change it if
necessary.