- Keep cord away from the heated surfaces.
- Keep heated surfaces away from contact with all skin areas. Do not touch barrel with fi ngertips. This unit is hot when in use. Do not let
eyes or bare skin touch heated surfaces.
- Do not place the heated unit directly on any surface while it is hot or still plugged in.
- Always unplug the appliance immediately after use.
- Never leave the appliance unattended when plugged in. Never use while drowsy or sleepy.
- Do not store the appliance immediately after use. Wait until appliance is completely cool before storing.
- Never block the air grills.
- If the appliance overheats, it will switch off automatically. Unplug the appliance and let it cool down for a few minutes. Before you switch
the appliance on again, check the grills to make sure they are not blocked by fl uff, hair, etc.
- Do not use the hot air styler for purposes other than drying and styling human hair.
- When the device is used in a bathroom, unplug it after use since the proximity of water presents a hazard even when the hot air styler is
switched off.
- For additional protection, we advise you to install a residual current device (RCD) with a rated residual operating current non exceeding
30mA in the electrical circuit supplying the bathroom. Ask your installer for advice.
- The airborne noise emitted by the appliance ≤ 90 dB(A).
- Do not pull or wrap power cord around the hot air styler.
- Do not direct hot air toward eyes.
- Attachments may get hot in use. Use care when handling them.
- Do not put the hot air styler down while it is operating.
- Check that the voltage rating of this appliance matches that of your supply.
- Position the power supply lead so that it is not likely to be walked on or pinched by things placed on or against them.
- Do not use the hot air styler in humid or damp conditions. Do not allow the appliance to get wet i.e. dripping or splashing, as this may
be dangerous.
- The slots and openings on the appliance are for ventilation. Do not cover or block them as it could lead to overheating. NEVER let children
push anything into the holes or slots on the hot air styler.
GENERAL FEATURES
Please read this instruction carefully before using this product and keep them in a safe place for future reference.
1. Cool tip
2. Bristle
3. Ceramic barrel
4. Handle
5. 0 – cool – low – high heat settings
6. Air in-let
- Overheat protection
- AC 220-240V ~ 50/60Hz, 1200W
- Cable length: 1,7m
- Product size: 40,5 x 32 x 26,5cm
IN THE BOX
Inside your hot air styler package you should have:
- Hot air styler.
- User guide. Read these instructions before use.
USE
What to do before fi rst use:
- Remove the packaging material and inspect the device for damages.
3