Sensor Information - Lucide Rgs-15W500 Montageanleitung

RGS-15W500 LED Driver with PIR Sensor Instruction
Example
Characters
This is a LED driver / power supply unit combined with infrared
Turn the sensor cover left or right you can find the adjusting knob.
It can identify day and night automatically. And the working light can be chosen freely and make it work
at night and not work in the day time.
Illuminated time can be adjusted according to the customer's desire.
Specifications
MODEL:RGS-1 W
PRI.:100-277V~ ,50/60Hz, Max:0.17A@100VAC
SEC.: 0mA, DC - V Max. 3VDC 3.5W
Detection range: 6-10m Max.
Time setting: 5 s-10 min ±1 min (adjustable)
Detection angle 120°

Sensor information

Note:please don't adjust the two functional buttons to excess. That is because the two
functional buttons were connected to the components directly, there is a small stopper in
each of the two components, when you adjust the buttons from start to end, the excessive
turn will damage the stopper and lead to the 360°non-stop turn around.The adjust range
limit is 270°, please do pay attention to this.
The factory intercalation:Light-control is 2000 lux, Time setting is 5 seconds.
Notes
Electrician or experienced human can install it.
Do not install on unstable objects.
In front of the detection window there should be no hinder or unrest objects effecting detection.
Avoid installing it near air temperature alteration zones for example: air condition, central heating, etc.
Please don't open the case for your safety if you find the hitch after installation.
COVER
Light-control: 15- 000LUX ±30LUX (adjustable)
Working humidity: <93%RH
Working temperature: -25 ~ +45
Power consumption: <0.5W
Installation height: 0.5~2.5m
6-10m
Light-control
setting
sensor
120°
GB
Time setting