PAVO 8004690 Bedienungsanleitung

ENGLISH
1 To program and change the user & administrative code
User code
1. First, open the door with your key. The keyhole is situated behind the override
cover plate (logo) beside the knob before you start to program your Safe. Insert the
key and turn it anti-clockwise, hold it and turn the knob clockwise to open the
cabinet.
2. Remove the battery compartment cover on the back of the door and place the (4×
AA type batteries 1.5V) into the battery holder correctly.
3. Press the red button under the battery cover, the yellow light will be on with two
beeps, please input the user code from 3-8 digits using any number from "0" to "9"
within 10 seconds, then press "C" or "E" to confirm it. You would hear two beeps, if
your resetting is succesful.
To reset the user code, press the red button and enter your new user code.
Then press "C" or "E" to confirm it.
Administrative code
1. Press two times zero and then afterwards the red button.
2. Enter the administrative code from 3-8 digits using any number from "0" to "9"
within 10 seconds, then press "C" or "E" to confirm it.
3. If you want to reset the administrative code from the safe please
do step 1 and step 2.
2 To open the Safe.
Input the user code you programmed, then press "C" or "E",the green light will be on,
please turn the knob within 5 seconds and pull out to open the safe.
Note: Each press the yellow light will flash with a short beep, indicating that microprocessor
confirmed it. If the yellow light keep on flashing with the beep means the code is wrong.
Three times' wrong code will result the microprocessor refuse to accept the input for 20 seconds,
if press three times' wrong code again will result the microprocessor refuse to accept for 5
minutes.
3 To close the safe
Close the door and turn the knob anti-clockwise will lock the safe.
4 How to use your override keys
For your convenience, we have engineered a manual override system for your safe, we supplied
2pcs override keys. These keys allow you to open the safe at all times, even when the batteries
are run down or when you have forgotten your code. The keyhole is situated beside the knob,
insert the override key and turn anti-clockwise, and then open the safe as usual.
5 To replace the batteries
When you input your personal code to open the safe, if the red light is on with green light, it
means the batteries are low and you should change the batteries. To be sure the batteries are
installed correctly. Please have a test before you close the door.
Please always use alkaline batteries only.
6 Installing the Safe
To reduce the risk of the safe, it can be secured to floor, wall or in a cupboard. For your
convenience, there are four holes on the back of the safe, therefore it can be fixed by the
expansion screws supplied.
Warning:
a- Please keep the override keys of the Safe in another safety place and do not inside the safe.
b- In the event the keys are lost, the code is misplaced and the batteries are weak. Then the
supplier does not take responsibility of this product.