Connecting A Controller; Operation; Replacing The Lamp - EuroLite Techno Strobe 550 Bedienungsanleitung

Connecting a controller

The TECHNO STROBE 550 can be connected with every standard 0/10 V controller.
Connect the strobe's REMOTE CONTROL IN-socket via a microphone lead and two ¼" mono-jack plugs with
the 0/10 V-output-socket of the controller.
If several TECHNO STROBE 550 are to be synchronized, connect the REMOTE CONTROL OUT-socket of
the first strobe with the REMOTE CONTROL IN-socket of the second strobe.
Please note that only strobes with the same flashing power are to be connected.
Connect the next strobes like described above and make sure that you do not connect more strobes like
stated in the user manual of the controller.

OPERATION

After you connected the effect to the mains, the TECHNO STROBE 550 starts running. On the rear panel ot
the TECHNO STROBE 550 there is a rotary control to adjust the flash-rate (1-12 flashes per second).
If you connected the TECHNO STROBE 550 with a controller, you can adjust the flash-rate via the controller.

REPLACING THE LAMP

The flash tube may be replaced by qualified staff only.
For replacement use genuine flash tubes only.
During the operation, the lamp reaches temperatures of up to 500° C.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
WAIT 5 MINUTES AFTER SWITCHING OFF BEFORE OPENING – Danger of life!
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Unscrew the fixation-screw on the connection-clasp between the strobe-body and the colour-cap.
Step 2: Hold the strobe-body and turn the colour-cap clockwise.
Step 3: Remove the colour-cap.
Step 4: Remove the old flash-tube from the lamp-socket.
Step 5: Put the new flash-tube into the lamp-socket.
Step 6: Replace the colour-cap and turn the colour-cap anticlockwise. Tighten the screw.
Do not operate this device with opened housing!
13