Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Please read through these instructions carefully before using this product. They contain
all the important information you need to familiarise yourself with its functions. Retain
these instructions in case you have any questions during the life of the product and pass
them on to other users or subsequent owners.
Intended use
this compressor has been designed mainly for inflating car and light commercial vehicle
tyres to the tyre pressures recommended by the vehicle manufacturer. It may also be used
for leisure products such as airbeds, air cushions and balls. To make the job easier in the
dark, the compressor has a built-in LeD work light. this LeD work light is not suitable for
lighting living areas.
Parts list
1 transparent cover
2 LeD base
3 LeD lights
4 top cover
5 Decorative panel
6 Bottom cover
7 Compressor 28 mm
8 Support pads
9 Adapters
Vibration dampers
On/OFF buttons
Buttons
Pressure sensor
Accessories
• Use only the accessories supplied with the product.
• 12 V cable with plug for the cigarette lighter
• Compressed rubber hose with screw lock valve
• 1 adapter each for balls and airbeds.
• Check that the vehicle's battery has enough charge to operate the compressor.
Safety instructions
• Do not let the compressor operate for longer than 15 minutes at a time or there will be a
risk of overheating. then leave it to cool for at least 30 minutes.
• Do not leave the compressor unattended during the inflation process
• Do not use the compressor whilst travelling
• The compressor may become hot during operation
• Operate only with 12 V direct current
• Operate only in a dry environment
• Check the device for any damage every time before using it. Do not start up the device if
any damage or malfunction has been detected or if it has come into contact with water.
• Repairs may only be carried out by trained staff.
• Do not carry the device by its cable or pull on the cable to take the device out of the
socket. to take the cable out of the socket, grip the 12 V plug.
• Do not wind the cable around sharp corners or edges
• Do not operate the device with wet hands
• Before any routine cleaning or maintenance remove the device from the socket and first
allow it to cool down sufficiently.
• Children must not play with the device.
• Suitable ambient temperature for use: -15 to +55°C.
Original operating instructions
3
2
1
4
5
6
7
8
9
Werbung
