Bluetooth Connect - Cooler Master Ch351 Bedienungsanleitung

ATTENTION
Please charge your new headphone for at least 2 hours before using for the first time.
MFB
PRESS
PUSH
2.4GHz Connect
Function
Power On
Connecting
Manual Pairing
Connected
Connect Fail
Disconnect
2.4GHz and BT Switch
Power off

Bluetooth Connect

Function
Power On
BT Searching
Pairing
*The 1st device
only*
Manual Pairing
Connected
*w/ 3 devices
pairing record*
Disconnect
BT Devices Switch
*W/ a pairing record for
more than 2 devices, the
maximum is 3 devices*
Power Off
Instruction / Description
Push and hold "MFB" for 2 seconds
Power on and enter to connection
searching
*It's already be paired at factory, please
avoid using when not necessary.*
Power on then press "MFB" for 6 seconds
Insert a paper clip or a SIM-eject tool into
the hole back of the dongle for 6 seconds.
Connection mode
Power off after 5 minutes
Unplug the dongle
Under power on, press "MFB" twice
Under power on, Push and hold "MFB"
for 4 seconds
Instruction/Description
Push and hold "MFB" for 2 seconds
to power on then press "MFB" twice
enter to BT mode
With pairing record:
Auto enter while switching from
2.4GHz mode to Bluetooth
When switch to BT mode, it will
automatically to pairing stauts if the
headset doesn't have pairing record
Under power on, press "MFB" for 6
seconds
Connection status
Disconnect with device, power off
after 5 minutes disconnected
Under BT mode, press "MFB"
once to switch
Under power on, Push and hold
"MFB" for 4 seconds
LED Status
●Red LED flashes once
Green LED
●.●.●.●.●.●.
slow flash
●●●●●●Green LED
fast flash
Green LED steady
Green LED
●.●.●.●.●.●.
slow flash for 5 minutes
Green LED
●.●.●.●.●.●.
slow flash for 5 minutes
As connection status
●●Red LED fast flash
twice and off
LED Status
Red LED flashes once
●
Blue LED
●.●.●.●.●.●.
slow flash
Blue LED fast flash
●●●●●●
Blue LED fast flash
●●●●●●
Blue LED steady
Blue LED slow
●.●.●.●.●.●.
flash for 5 minutes
Blue LED fast flash
●●
twice and off
Red LED fast flash
●●
twice and off
Voice Prompt
Power on
/
Pairing
Connected
/
Disconnect
Low Latency or Bluetooth
Power off
Voice Prompt
Power on -> Bluetooth
/
Pairing
Pairing
Device one Connected /
Device two Connected /
Device three Connected
Disconnect
Device One, Device Two,
Device Three
Power off