Safety Instructions; Packaging Information; Product Introduction - Enabot Rola Bedienungsanleitung

EN

Safety Instructions

Please read the following safety instructions carefully and take normal safety
precautions before using this product.
1. The product is suitable for DC output 5V
adapter that complies with relevant national and regional standards.
2. If the device cannot work properly due to damage from falling, being placed
outdoors, or water intrusion, please stop using it immediately.
3. Please do not place, charge or use this device outdoors or in the bathroom. Place the
equipment at least one meter away from the pool. Do not place the device on wet ground
or expose it to rain or snow.
4. Do not touch the device's power supply with wet hands.
5. Do not use damaged power cords or plugs. If the power cord is damaged, please
contact your supplier or the manufacturer's after-sales maintenance department
immediately to replace it with a new one to avoid damage.
6. When unplugging the charging device, please hold the charging device with your
hands and do not drag the power cord. Do not use power extension cords for power.
7. When in use, the equipment must be provided with safely-rated low voltage that
meets the relevant requirements.
8. Please place the device on a table away from heat sources, fire sources or other high
temperatures.
9. Do not immerse the base in water or any other liquid.
10. If the base is exposed to water, please dry the outer surface before continuing to
use it.
11. Do not use hot water in the bucket.
12. Please do not disassemble, modify or repair this product by yourself, otherwise you
will lose all warranty and service rights.

Packaging Information

① Water Fountain ② Charging Cable

Product Introduction

④ Nozzle
⑤ Stainless steel basin
⑥ Filter
⑦ Filter tray
⑧ Outlet pipe
⑨ Bucket
⑩ Outlet pipe bracket
2A power adapter. Please use a power
③ Manual
Sponge
11
Rotor
12
Bucket base
13
Status indicator light
14
Touch button
15
PIR sensor
16
Type-C charging port
17
1. Status Indicator Light
Status Indicator Light
Flashing blue
Steady white
Steady green
Flashing red
2. Operation Key
Operate
Press and hold for 3 seconds(from off state)
Press and hold for 3 seconds (from on state)
Click
Click + long press for 3 seconds
3. Mode Description
Mode Description
Continuous water mode
The device continuously discharges water(must be plugged in)
The device will discharge water once if it senses the approach
of a person/pet
Sensor mode
*By default, the device sleeps for 15 seconds after each water discharge. If no water
is detected within 2 hours, the device will automatically discharge water once.
*The water-release time and sleep time can be set manually in the ROLA App
Working Status
Waiting for network configuration
continuous water mode
sensor mode
low battery reminder (wireless version)
State
power on
enter network configuration mode
switch water outlet mode
power off
State