OPERATION INSTRUCTION
1. Use as directed:
This product exclusively serves lighting purposes and may
• Not be exposed to strong mechanical loads or to strong contamination�
• Only be installed and operated after a condition inspection in case the product is
dirty or has been moistened through storage�
2. Technical data:
• Power: 1�5W
• Operating voltage: DC 3�7V
• Luminous flux: 165lm
• LED: 2835/120
• Lithium battery: 4000mAH*1
• Charging time: 5h
• Operating time: 10-66h
• Class: III
• Safety type lamp: IP20
3. Charging:
1) This product can be charged with a mobile phone charger that fulfills the following criteria:
2) INPUT: AC100-240V 50/60Hz, OUTPUT 5V – 1A, USB line 1�2M
3) ATTENTION: INDOOR only!
4) Connect the light to the USB-C cable�
5) During the charging process, a red light illuminates on the touch sensor� Once the light is fully charged,
the red light goes out�
4. Instructions:
1) Quick touch <1s: touch once to turn light on; touch again to turn off�
2) Long touch >6s (while the lamp is switched on): touch for a longer period of time and the light lumen
will increase gradually� Move your hand away from the lamp shade and the light intensity will remain the
same� When you apply the long touch again, the light lumen will decrease gradually until the light is off�
3) Long touch >6s (while the lamp is switched off): The light turns on and with a short (<1s) press, you can
switch between the color temperatures of 2200 K & 2700 K� The desired color temperature can be saved
with a long (>4s) press�
5. Attention:
1) During the charging process, the tilt angle of the pole may not be more than 15°, otherwise the lamp will
fall down�
2) The battery has an overcharge protection function;
3) Please refer to the local environmental law for recycling and disposing of the battery�
4) Please charge the lamp regularly, otherwise the battery life may be affected�
5) The light should not be continuously charged/kept on the charging station as it could damage the battery�
GB
| 7