Start Operation; Control Panel - Kuppersberg Rbw 46 Technischer Pass

TECHNICAL PASSPORT
Built-in wine Cooler
OPERATION

START OPERATION

1. Cleaning the compartment.
Before power on, clean inside of the
appliance and check the drainage pipe in
good connection (For details, please refer
to the «Maintenance and cleaning»).
2. Placement.
Before power on in the first time, keep
it static at least 30 minutes.
3. Power on.
The appliance start operation and
it will cool down inside after 1 hour,
otherwise you should check the power
connection.

CONTROL PANEL

All keys would be invalid if in lock
mode. Please unlock first.
ON/OFF
1. Keep pressing the key 3 seconds,
power down, goes to stand-by mode.
2. Keep pressing the key again 3 sec-
onds to return back to normal working.
Light
Press the key, turn on or turn off the
LED lights inside. In stand-by mode, the
key is invalid.
20
UP
Press the key once, LED Display in reg-
ular flash showing current set tempera-
ture. Continue pressing to adjust set tem-
perature, one press increases 1
flash quit after 5 seconds detecting no
press and new set temperature save. LED
display return to show actual temperature
inside.
Down
Press the key once, LED Display in
regular flash showing current set tem-
perature. Continue pressing to adjust set
temperature, one press reduces 1
lar flash quit after 5 seconds detecting no
press and new set temperature save. LED
display return to show actual temperature
inside.
Child Lock
(Combination key)
1. Lock: Press both keys at the same
time for 3 seconds to lock.
2. Unlock: Press both keys at the same
time for 3 seconds to unlock.
Fahrenheit/Celsius display
interchange
Switch temperature display between
Fahrenheit and Celsius by pressing both
keys at the same time for 2 seconds.
Electric push-rod
control button
Press this button for a short time, and
the button light flashes. At this time, the
push-rod pushes the door open. The push
ENGLISH
С. Regular
о
С. Regu-
о