Technical Data - Arovo Re-Load 3-In-1 Wireless Charge Bedienungsanleitung

TECHNICAL DATA

- Input: DC 12V-2A / 9V-2A / 5V-3A
- Output voltage: watch = 2.5W max, earphone = 3W max, mobile phone = 15W max
- Wireless output for phone: 5W /7.5W / 10W / 15W max. single coil
- Wireless output for earphone, single coil with 3W max
- Wireless output for smartwatch, single coil with 2.5W max
- Maximum radio frequency power: 5.16 dBuA/m@10m
- Frequency band: 110kHz-148kHz for phone & earphone 328kHz and for smartwatch
- Including 1.2m type-C charging cable
WARNINGS
- Read the manual carefully before use. Keep the manual for future reference.
- The manufacturer is not liable for consequential damages or for damages to property or persons
caused by no observance of the safety instructions and Improper use of the USB charger.
- The appliance can be used by children from 8 years and above and by persons with a physical,
sensory, mental or motor disability, or lack of experience and knowledge If they are supervised or
instructed on how to use the USB charger in a safe way and understand the hazards involved.
- Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
- Only use the appliance for its intended purposes. Do not use the appliance for other purposes
than described in the manual.
- Do not use the appliance If any part Is damaged or defective. If the appliance is damaged or
defective, replace the appliance immediately.
- The appliance is suitable for indoor use only. Do not use the appliance outdoors.
- Keep out of reach for children
- The appliance is suitable for domestic use only. Do not use the appliance for commercial purposes.
- Do not use the appliance in locations with high humidity, such as bathrooms and swimming pools.
- Do not use the appliance near bathtubs, showers, basins or other vessels containing water.
- Connect a suitable charging cable to your appliance and the USB port. Note: To ensure safety and
best performance, use a good charging cable for your USB device.
- Insert the mains plug into the wall socket. The appliance will detect the best charging mode and
start charging your device automatically. Note: the appliance and your device should indicate
that it is in charging mode.
- Always disconnect the appliance charger from the wall socket when not in use.
- Do not leave the appliance unattended while the mains plug is connected to the mains supply.
- Do not attempt to repair the appliance. If the appliance does not operate correctly, replace it.