DJ-Tech USB 7330 Bedienungsanleitung

USER MANUAL
USB 7330 – USB 7331 – USB 7332
IMPORTANT
Use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
CD Player Functions:
1. POWER BUTTON
Press the power switch to turn the unit on. To switch the power off press the power switch again.
2. JOG & SHUTTLE WHEELS
Shuttle: Use the dial to select the scanning direction and speed. The disc is scanned in the
forward direction when the shuttle dial is turned clockwise from the neutral position, in the reverse
direction when the shuttle dial is turned counterclockwise. The scanning speeds up when the
shuttle dial is turned faster.
Jog : In pause mode, if you turn the jog, the point at which the sound is being produced moves by
a number of frames corresponding to the number of clicks. Clockwise moves the point forward;
counterclockwise moves the point backward. In play mode, the jog increases or decreases the
speed of the song. (clockwise : increase, counterclockwise : decrease).
3. TIME BUTTON
Use this knob to choose the time mode: Elapsed time, remaining time or total remaining time.
4. REPEAT BUTTON
Use this button to repeat one track or all the track of the CD.
5. IN BUTTON ( LOOP SYSTEM )
This button sets the beginning of the loop. The Loop indicator on the display flashes.
6. CONT. / SINGLE BUTTON
Press these to switch between the SINGLE and CONTINUOUS play mode. The selected mode is
indicated on the LCD. In SINGLE mode, after each track, the unit stops the reading. In
CONTINUOUS mode, the unit read all track and stops.
7. PROG BUTTON
In STOP mode, you can program several tracks (20 tracks max.) :
- Press the STOP button to enter in the stop mode
- Press the PROG button to enter in the program mode
- Use the skip track buttons to choose the track you want to listen then press the PROG button to
enter your choice.
- Use one more time the skip track buttons to choose the track you want to listen then press the
PROG button to enter your choice.
- Repeat the operation to select all the track you want to listen
- Press the PLAY / PAUSE button to start the playback
8. OUT BUTTON ( LOOP BUTTON )
When you press this button, you set the end point of the seamless loop and you start the loop. To
finish the loop, press again this button.
9. TRACK SELECT BUTTONS
Pressing 0-9 buttons, allow you to select tracks from the CD.
1