FRIATEC FRIATOOLS Kurzanleitung Seite 6

EN
Open the reader wand bag at the pushbuttons.
und assemble the scanner
from the reader wand adapter
has to be unscrewed
data cable) by turning counter-clockwise
Connect the FRIAMAT barcode scanner (without reader wand adapter) with the
connector of the FRIAMAT data cable (Fig. 3). Tighten the connection
tight" without tooling. Close the scanner bag at the pushbuttons.
NOTICE
Remove reader
Do not operate the FRIAMAT barcode scanner with reader wand adapter.
After switching
barcode scanner
by the verification
the FRIAMAT
ready to use.
3. Operation
FRIAMAT barcode
FRIAMAT barcode scanner over the barcode and push the reading button. The
barcode is recorded
over the complete
in any other position.
Good Read
Ill,
6
bag. Carefully
and the connectors.
from both connectors
wand adapter!
on the FRIAMAT fusion unit the switch-on
sounds (4 short signal tones in rapid succession),
tone of the FRIAMAT fusion
barcode scanner indicates
scanner reads
by a red light-band,
barcode. The barcode will not be read if the red light-band
Remove the reader wand bag
remove the heat shrink tube (Fig. 1)
(reader wand cable and FRIAMAT
(Fig. 2).
unit. The switch-on
that the FRIAMAT
the barcodes contact-free.
which should be centred horizontally
Bad Read
The reader wand adapter
signal of the FRIAMAT
followed
signal of
barcode scanner
Position the
Bad Read
II II I II
III
il
"hand-
is
is