Alpine DVR-Q1000 Kurzanleitung Seite 9

Using the continuous recording features
Connect the power cable to the product's DC-IN power port and then turn
on the vehicle's electrical accessories or start the engine. The voice guide
will indicate that continuous recording has started.
Mode
Continuous
recording
Incident
continuous
recording
• Wait until the product is completely booted up after turning it on, and
then begin operating the vehicle. The video recording does not begin until
the product is completely turned on (booted up).
• When incident continuous recording starts, a double "beep" sounds as
a notification.
• To enable recording, you must insert a memory card into the product.
Recording manually
You can record a scene you want to capture while driving and store it as a
separate file.
To start manual recording, press the manual recording (REC) button. Then,
the voice guide will indicate that manual recording has started.
Mode
Manual
recording
8
Operation description
During driving, videos are recorded in 1 minute
segments and stored in the "cont_rec" folder.
When an impact to the vehicle is detected, a video
is recorded for 20 seconds (from 10 seconds before
the detection to 10 seconds after the detection) and
stored in the "evt_rec" folder.
Operation description
When you press the manual recording (REC) button,
a video will be recorded for 1 minute (from 10
seconds before to 50 seconds after pressing the
button) and stored in the "manual_rec" folder.
REC LED
Red
(light on)
Red
(flickers)
REC LED
Red
(flickers)