Playback; Manual Run Chase; Running In Sound-Mode; Running In Auto-Mode - Chauvet Obey 10 Bedienungsanleitung

Playback

Manual Run Chase

When power is first turned ON, the controller will be in manual scene mode.
Action ·
1) Make sure neither MUSIC TRIGGER nor
AUTO TRIGGER LED's on the LED
display are on.
2) Select the program CHASE button that
stores the scene you want to run manually
by using the STEP UP/DOWN.

Running in Sound-Mode

Action ·
1) Press the MUSIC/ADD button until the
MUSIC TRIGGER LED turns on.
2) Select the CHASE you wish to operate.
3) Press the AUTO/DEL button to exit the
Chase.

Running in Auto-Mode

Action ·
1) Press and hold the AUTO/DEL button until
the AUTO TRIGGER LED turns on.
2) Select the CHASE you wish to operate.
3) You can set the time between steps by
moving the SPEED fader and the fade
time of the step by moving the FADE
TIME fader.
4) You can change Banks while in operation
by using the STEP UP/DOWN buttons.

Running Sequential chases

Action ·
1) Press either AUTO/DEL or MUSIC/ADD
buttons to select the trigger mode.
2) Press the CHASE button for each chase
you wish to add to playback.
3) Adjust the Chase speed by changing the
SPEED fader.
Obey™ 10 User Manual
¥
Notes
If you are in programming mode you can also
press and hold the PROGRAM button until the
Program LED goes off.
¥
Notes
In the Sound mode, programs will be triggered by
the sound using its built-in microphone. All scenes
in a Bank will chase.
¥
Notes
In the Auto mode, programs will be triggered by
controllers fade and speed time as set on the
faders. All scenes in a Bank will chase.
CAUTION! The fade setting should never be
slower than the speed setting or the scene will
never complete execution.
¥
Notes
Chases must already be programmed.
The chases will run in the order they are pressed
To delete a chase from the playback, press the
CHASE button you wish to exclude from the
playback.
14 Rev.4