Unpacking The Product - Proregal Rjr42 Bedienungsanleitung

A. SAFETY INFORMATION (EN)
2. Unpack and check

2.1 Unpacking the product

WARNING
Choking hazard due to packaging material and
swallowing small parts.
Dispose of the packaging material immediately
in the household waste in accordance with the
regulations.
Keep the packaging and small parts required
for repackaging away from moisture and out of
the reach of children.
ATTENTION
Material damage.
Pointed, sharp and scratching objects can damage
the product when opening the packaging.
Do not use any pointed, sharp or scratching
objects to open the packaging.
Carry out the following steps carefully.
1. Remove adhesive and securing tapes by hand or use
scissors.
2. Place the carton with the direction arrows pointing
upward.
3. Open the packaging box.
4. Take all parts out of the box.
5. Lay the parts side by side on a clean, soft, and flat surface.
6. Check the contents for completeness and integrity.
7. Read the user and assembly instructions!
2.2 Check the contents of the delivery.
ATTENTION
Material damage.
Use with missing or defective parts can damage the
product.
Do not use the product incompletely
assembled or with defective parts.
Check that the scope of delivery is complete
and undamaged.
Hergestellt für Procommerce Group GmbH - Am Kreutweg 1 - 97204 Höchberg - Germany
3. Assemble
CAUTION
Verletzungsgefahr und Sachschaden.
Risk of injury and damage to property.
Modifying the product can lead to injuries and
damage to property.
Only use the product with the original parts
supplied and in its original condition.
Only use spare parts and accessories
approved by the manufacturer.
CAUTION
To secure your unit:
Use the holes on both sides of the base to
secure the unit by locking it and/or attaching it
with a chain to prevent theft or damage.
ATTENTION
The product is fully assembled and ready for use.
However, we recommend adding additional weight to
the base to prevent tipping over in adverse weather
conditions.
ATTENTION
3.1 To add additional weight:
1. Unscrew the black knob from the unit and remove
it. Then tilt the neck to release the opposite tab
from the slot, and remove the upper unit from the
base.
2. Fill the inner container about halfway with sand.
3. After adding the weight, place the upper unit back
onto the base. While tilting the neck, align the tab
of the upper unit with the slot on the base. Bring
the neck to an upright position so the tab locks into
the slot.
4. Align the hole at the front of the lid with the nut
insert on the base, and screw in the knob to secure
the upper and lower units.
EN