Explore Scientific RAC0003 Bedienungsanleitung Seite 3

GETTING STARTED
INSERT BATTERIES
1. Remove the battery door from the back.
2. Insert 2x AA (LR6)/1.5V batteries. Please ensure
the polarities (+/-) of the batteries match upon
installation.
3. Reattach the battery door.
CLOCK
SET THE TIME MANUALLY
1. Turn the hour/minute knob clockwise.
2. To set the second hand, remove the batteries so
that the second hand stops turning and re-insert the
batteries to restart the second hand at the correct
position.
ALARM CLOCK
SETTING THE ALARM
Set the desired alarm time by turning the alarm setting
wheel in the direction of the arrow. The alarm time
hand will turn counter-clockwise.
SWITCHING THE ALARM ON/OFF
Move the slider switch to the ON or OFF position to
activate or deactivate the alarm respectively.
TROUBLESHOOTING
The time is accurate to the nearest few minutes over
the course of a year. If the time display suddenly
malfunctions, replace the batteries.
MOUNTING
You can place the clock on a level surface or mount it
on the wall using the cut-out on the back.
NOTE: Before mounting, make sure that the wall is
suitable for the clock to be installed. There should be no
electricity, water, gas or other cables running through the
wall at the installation location.
SPECIFICATIONS
Dimensions
160 x 40mm (L x W)
Weight
268 g (Exclude batteries)
Power:
2x AA (LR6) 1.5V batteries
EC DECLARATION OF CONFORMITY
Hereby, Guangzhou
Instruments Co., Ltd declares that the
RAC0003 product complies with directive
2014/53/EU.
The full text of the Declaration of Conformity is
available at the following web address:
https://www.explorescientific.it/certificati-di-
conformita
RCM DECLARATION OF CONFORMITY
The product complies with electrical safety,
EMC and radio spectrum regulatory
requirements for products supplied to the
Australia or New Zealand market.
NOTES ON CLEANING
• Remove the batteries before cleaning.
• Only use a dry cloth to clean the exterior of the
device. To avoid damaging the electronics, do not
use any cleaning fluid.
• Protect the device from dust and moisture.
DISPOSAL
Dispose of the packaging materials properly,
according to their type, such as paper or
cardboard. Contact your local waste-disposal
service or environmental authority for information on
the proper disposal.
EN
IT
DE
FR
ES
Bresser Optical
3