Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly Instruction
（The size will be according to regular measurements）
1
2
Decorative
cover
Chair leg
base
First, separate the base into two
Use 10 M6X14 screws to connect the
parts: the decorative cover and the
five chair leg tubes to the base.
chair leg base.
4
5
Use 4 M6X20 screws to install the
Insert the lumbar support into the
mechanism and seat cushion.
backrest slot hole and tighten the
lumbar support knob clockwise.
7
8
Use 6 M6X35 screws to connect the
Align the assembled upper part of
seat cushion and armrests. Use a
the chair with the gas lift and insert it.
wrench to tighten them clockwise
while also tightening the screws
connecting the backrest and armrest.
1. One chair can only bear one person's weight;
2. Please use on the flat floor;
3. Not allowing the child under 5 years old to sit on the chair alone;
Installation
4. Please don't sit on the armrest, in case cause some danger;
5. Do not stand on the chair or use it as a ladder or footsteps;
Safety
6. Please don' t put overweight on the chair, or used as trolley;
Guideline
7. Don' t use sharp or hooked objects to scrape the chair and do not get it close to the fire;
8. For your safety, no disassembly to the gaslift is allowed.
01
3
Insert the wheels into the chair legs,
then snap the decorative cover onto
the chair legs. Finally, insert the gas
lift into the middle hole of the base.
6
Use 4 M6X25 screws to connect the
backrest and armrests. Use a wrench
to tighten them clockwise to 80%
tightness.
9
Align the headrest with the holes on
the upper part of the backrest, and
use 2 M6X25 screws to install the
headrest. Use a wrench to tighten
them clockwise, and finally install the
headrest decorative cover.
Note: Please sort the screws and measure their lengths beforehand for easier assembly.
Functions
（The size will be according to regular practice）
The headrest can be adjusted
up and down, as well as forward
and backward.
The lumbar support can be
adjusted up and down.
To control the tilt, push or pull
the right-side lifting rod of the
base.
Height adjustment: When sitting
in the chair, lift it to lower the
chair. When not sitting in the
chair, lift it to raise the chair.
Parts List
（Take the actual size as the reference; there is one spare screw and washer for each type/model.)
Backrest*1
Seat cushion*1
Chair leg tubes*5
Mechanism*1
Headrest and backrest/armrest screws (M6X25)*6+1
Mechanism screws (M6X20)*4+1
Lumbar support kgnob*1
Wheels*5
0
1
2
3
4
The armrests can slide forward
and backward, as well as
rotate left and right.
The rotating spring knob
adjusts the reclining force.
The seat can rotate 360°.
Pair of armrests*1
Gas lift*1
Lumbar support*1
Headrest*1
Armrest screws (M6X35)*6+1
Base*1
Chair leg screws (M6X14)*10+1
Headrest decorative cover*1
Wrench*1
5
6
7
8
9
10
cm
02
Werbung
