ZOSI C280 Schnellstartanleitung Seite 7

To add additional cameras to the NVR, follow these steps:
1. Power on the camera and connect the NVR and camera with an Ethernet cable.
2. Right-click on the screen to open the menu.
3. Select "IPC Channel Configuration" and click the "Search" button.
4. Click "Add All" to connect the cameras. A "Connected" status indicates a successful
connection.
5. Disconnect the Ethernet cable from the camera and NVR, and wait for the camera to
switch to WiFi mode.
Install the Camera
1. Installation Precautions
• Avoid directing the camera towards strong light or reflective objects, including
sunlight, lights, glass, mirrors and other areas with strong refraction of light sources.
• Do not install at location with objects covering or obscuring the camera.
• Avoid mounting the camera in places where too dim, and point the camera towards a
well-lit area. For better image quality, make sure the camera and the captured subject
are at the same lighting conditions.
• For better image quality, it is recommended to clean the lens with a soft cloth from
time to time.
• Do not expose the power port to water or moisture, or blocked by dirt or other things.
• Do not install the camera where rain and snow may hit the lens directly.
• Camera may work in extremely cold conditions as low as -10°C because it will
produce heat when powered on. You may power the camera indoors for a few minutes
before installing it outdoors (Only for outdoor cameras)
NVR
Network Cable
PT Camera
Power Cable
5 English
Power Adapter