Waferlock R400 Benutzerhandbuch Seite 7

WAFERKEY: Pairing R400 Gateway
Add a New Device: R400 Gateway
Step 4
Scan QRcode on Gateway
*QRcode can be found at the
side of Gateway.
Note
• Please be patient until steps are completed. Sudden interruption or leave may cause a failure to pair.
• When pairing with the lock in Step 5, the lock should make a short beep. When done, the lock
should make three short beeps.
• In Step 6, make sure all connections have been done and then click "FINISH THE SETTINGS" button"
to nish the setting.
When done, you will be directed to the R400 Gateway Management Page.
Refer to"Gateway Setup Page" for knowing Gateway better. Start to enjoy the smart
management of remote control, the functions of locking / unlock doors remotely and
remote distribution of passwords for personnel management on the control page.
5
Step 5
Pair Gateway with your
phone and lock
*Please be patient until all steps
are completed.
WAFERLOCK CORPORATION
Step 6
Make sure all connection
done and then click
"FINISH THE SETTINGS" button