Royal Catering RCEC-40/700C2B Bedienungsanleitung Seite 8

3. Turn the temperature controller clockwise to adjust to the desired temperature. The highest power is at the
first setting, followed by the second, with the third being the lowest. The yellow heating indicator will light
up, and the green light will turn off, indicating that the stove is working, and the heating element is active.
4. Once the desired temperature is reached, you can turn the temperature controller to the second or third
setting to maintain the heat.
NOTE
• Regularly clean any oil from the burner plate to prevent damage and extend the life of
the machine.
• If any abnormal conditions occur during use, stop the machine immediately. After
troubleshooting and resolving the issue, you may resume using the stove.
Lower Oven
1. Connect the power supply, and the green indicator light on the power switch will illuminate, showing the
oven is powered.
2. Turn the temperature controller clockwise to adjust to the desired temperature. The yellow heating
indicator will light up, and the green indicator will turn off, indicating that the heating element is active and
the oven is heating.
3. When the oven reaches the set temperature, the temperature controller will automatically cut off the power.
The yellow indicator will turn off, and the green indicator will turn back on, showing that the heating element
has stopped. As the temperature slightly decreases, the controller will reconnect the power, the yellow
indicator will light up again, and the green one will turn off. This cycle repeats to maintain the set
temperature.
NOTE If any abnormal conditions occur during use, stop the machine immediately. After
troubleshooting and resolving the issue, you may resume using the oven.
Maintenance
• Before cleaning and maintenance, ensure the power supply is turned off to prevent accidents.
• After daily use, wipe the surface and power cord with a damp cloth and a non-corrosive cleaner. Do
not use water directly to clean the machine, as this could damage its electrical components.
Troubleshooting
Phenomenon
The plug is connected, but the
indicator light is off and the
machine does not heat.
The heating indicator light is off,
and the burner plate or oven is
not heating.
The power supply indicator light is
on, but the set temperature is not
reached.
EN
Possible Reasons
The plug is not properly
connected.
1. Loose or disconnected
connection of the burner
plate or heating element.
2. The burner plate or heating
element is burnt out.
The temperature controller or
switch is burnt out.
Handling Methods
Reinsert the plug securely.
1. Tighten the connections or
screws at both ends of the
burner plate or heating
element.
2. Replace the burner plate or
heating element.
Replace the temperature
controller or switch.