Midea SC2 Bedienungsanleitung Seite 7

2-2. Install mopping assembly:
Note: If the machine is used for hard floor, it needs to
install the mopping assembly and mop cloth; If the
machine is used for carpet, it needs to install the sliding
plate in addition to the mopping assembly and mop
cloth.
Install mop cloth: Attach the mop cloth to the bottom
of mop, as shown in Figure 6;
2-3. Align the notch of mopping assembly with the button
on the front of main body. When you hear a "click", it is
installed in place, as shown in Figure 7.
2-4. Modes and operation in mop state:
Preheating Mode: Check according to the precautions and make sure
everything is OK. Insert the plug into the socket, and the red light on handle
will flash, indicating that the machine enters preheating mode;
Standby Mode: About 15 seconds after entering preheating mode, the red
light will turn on, indicating that the machine switches to standby mode;
High-flow Mode: When the machine is in standby mode, press the ON/OFF
button, and the blue light in the right will turn on, indicating that the machine
switches to high-flow mode;
Low-flow Mode: When the machine is in high-flow mode, press the ON/OFF
button, the blue light in the right will go out, and the blue light in the middle
will turn on, indicating that the machine switches to low-flow mode;
When the machine is in low-flow mode, press the ON/OFF button again, all
the blue lights will go out, and the machine will return to standby mode. Please
see Figure 8 for the position of ON/OFF button.
ON/OFF
MODE
Figure 8
7
EN
Figure 6
Figure 7