Herunterladen Diese Seite drucken
IN231200400V01_GL
B20-105V00
EN_NOTES:
• At least twice a year, lubricate the
top and bottom of the drawer slides.
• A void opening more than one
loaded drawer simultaneously.
• Maximum load : 310 lbs.
FR_NOTES :
- Au moins deux fois par an, lubrifier
le haut et le bas des glissières du
tiroir.
- Ne pas ouvrir plus d'un tiroir chargé
simultanément.
- Charge maximale : 310 lbs.
ES_NOTAS:
- A l menos dos veces al año,
lubrique la parte superior e inferior
de las guías de los cajones.
- A nule la apertura simultánea de
más de un cajón cargado.
- Carga máxima : 310 lbs.
PT_NOTAS:
- Pelo menos duas vezes por ano,
lubrificar a parte superior e inferior
das corrediças da gaveta.
- Não abrir simultaneamente mais do
que uma gaveta carregada.
- Carga máxima: 310 lbs.
DE_HINWEISE:
- Schmieren Sie mindestens
zweimal pro Jahr die Ober- und
Unterseite der
Schubladenführungen.
- Öffnen Sie nicht mehr als eine
beladene Schublade gleichzeitig.
- Maximale Belastung: 310 lbs.
IT_NOTE:
- Almeno due volte all'anno,
lubrificare la parte superiore e
inferiore delle guide dei cassetti.
- Non aprire contemporaneamente
più di un cassetto carico.
- Carico massimo: 310 libbre.
loading

Inhaltszusammenfassung für HOMCOM B20-105V00

  • Seite 1 IN231200400V01_GL B20-105V00 EN_NOTES: • At least twice a year, lubricate the top and bottom of the drawer slides. • A void opening more than one loaded drawer simultaneously. • Maximum load : 310 lbs. FR_NOTES : - Au moins deux fois par an, lubrifier le haut et le bas des glissières du...
  • Seite 3: Maximum Load

    MAXIMUM LOAD...
  • Seite 4 PART ① ② ③ ④ ⑤ ⑥ ⑦ ⑧...
  • Seite 5 Removal of Assembly EN_Place the cabinet on its back on a flat surface. Using a screwdriver, remove the four bottom screws. Remember to save these screws for later use. FR_Placez l'armoire sur le dos sur une surface plane. À l'aide d'un tournevis, retirez les quatre vis du fond.
  • Seite 6 Assembly of casters EN_Insert the wheels into the cabinet ' s bottom holes. If the wheel does not stay in position, loosen the ring around the axle by spreading it with a screwdriver. If the wheel is difficult to enter the hole, tighten the ring around the axis with a clamp. These adjustments should be minimal (no more than 1mm).
  • Seite 7: Locking System

    Two casters with brakes Locking system Drawers EN_To unlock the drawers, open the tool chest, slide the drawers out and then close the tool chest. To lock the drawers, open the tool chest, slide the drawers in and then close the tool chest.