Maintenance - Ruris Rmx1210 Bedienungsanleitung

EN
3.Make sure the battery is properly connected to the charger.
4. After charging is complete, the green LED will stay on.
5. To remove the battery from the charger, slide the battery back.
Installing the battery
1) Before inserting or removing the battery, you must release the
switch and make sure the car stops.
2) To insert the battery, make sure the ribs are aligned with the
grooves on both sides, then insert the battery into the slot.
Please make sure it is fully inserted until it makes a "locking"
sound. If not locked, the battery may fall out accidentally.
3) To remove the battery, press the release button, then remove
the battery in the direction of the arrow.
Drill installation and removal
1) Before inserting the accessory into the chuck, lightly
grease its shaft.
2) Slide the locking sleeve back and insert the drill bit into
the chuck hole. Check that the keyway on the drill/chisel is
properly seated in the chuck by carefully turning the
drill/chisel until it locks into place. Release the locking
sleeve.
3) To remove the drill/chisel, slide and hold the locking sleeve
back, then remove the drill/chisel from the chuck.
Direction of rotation switch .
Always check the direction of rotation before operation. Only use the reverse switch
after the tool has come to a complete stop. Push the direction switch from right to
left or vice versa depending on the desired direction of rotation. Changing the
direction of rotation before stopping the tool can damage the tool. When not using
the rotary hammer, always set the reverse switch lever to the neutral position.
Changing the direction of rotation is only done with the car stopped. Before use,
check the set direction of rotation.
Function control button .
Use the function control button, select other desired operation functions. Turn
the function control knob to the appropriate position to select a different
operating mode.
Rotation without percussion
For drilling operations in wood, metal, plastic, it is necessary to unlock the
function switch and turn it to the non-percussion rotation mark.
Rotopercussion.
For drilling operations in concrete, masonry, etc. it is necessary to unlock the
function switch and turn it to the rotary impact mark.
Always keep guards, vents and engine housing clean, free of dust and dirt. We recommend that you clean
your device every time you use it. Clean the equipment regularly with a damp cloth. Do not use cleaning
6

6. MAINTENANCE

Buton de
eliberare
acumulator
Manșon blocare
mandrină
Comutator
direcție de
rotație
Acumulator