Maytronics Dolphin Service Kit Bedienungsanleitung Seite 7

3.3 Testing the Motor Unit Terminal
Check if the motor unit terminal is clean and dry. If yes, then skip to Step 4.
If there is water and corrosion in the motor unit terminal, then continue to step 3.3.1.
3.3.1
Clean the terminal with air pressure
(cover it with paper to prevent dirt from getting
into your eyes). Put alcohol inside the terminal
and wait for a few minutes.
3.3.3
Clean the terminal again using air pressure
(cover it with paper to prevent dirt from getting
into your eyes).
Dolphin Service Kit
| User Instructions
3.3.2
Clean inside the terminal using a paint
brush attached to an electric screw driver.
3.3.4
The terminal is now clean.
Note: If the terminal is not yet clean, repeat the
process and replace the retrofit connectors and
seals (P.N 9991273).
5