Knick ZU1207 Kurzanleitung

Knick
Elektronische Messgeräte
GmbH & Co. KG
Beuckestraße 22
14163 Berlin
Germany
Phone: +49 30 80191-0
Fax: +49 30 80191-200
info@knick.de
www.knick-international.com
Copyright 2024 • Subject to change
Version 2
This document was published on August 23, 2024
The latest documents are available for download on our website
under the corresponding product description.
TE-ZU1207-KNXX02
103510
English
Safety
This document contains important instructions for the use of the
product. Always follow all instructions and operate the product with
caution. If you have any questions, please contact Knick Elektronische
Messgeräte GmbH & Co. KG (hereinafter sometimes referred to as
"Knick") using the information provided on the back page of this
document.
Also read the user manual of the associated SensoGate (WA130 or
WA130H) and follow the safety instructions described in it.
Intended Use
The ZU1207 adapter is used to convert the existing outlet hose of a
SensoGate WA130 or WA130H. The adapter enables an outlet hose to
be connected using a ½" Tri-Clamp clamp connection. The inner
diameter of the Tri-Clamp is 7.7 mm.
Package Contents
• Adapter with pre-assembled O-ring 8 x 1.5 mm
• Installation Guide
Structure
1 2
1 ⅛" Thread
2 O-ring 8 × 1.5 mm (pre-assembled)
4 3
3 Tri-Clamp ½" with an inner diameter
of 7.7 mm
4 A/F 10
ZU1207
Installation Guide
Adapter, Tri-Clamp 1/2 Inch
Read before installation.
Keep for future use.
Assembly
Note: If the SensoGate was in operation, there might be residue of the
rinsing or process medium in the calibration chamber.
1
01. Rinse and clean the calibration chamber of the SensoGate before
assembly, if necessary.
02. Remove the exististing outlet port (1).
03. Screw the adapter (4) with O-ring 8 × 1.5 mm
(2) until it stops firmly.
www.knick-international.com
2 3 4
(3) into the opening