Cocraft 40-9363 Bedienungsanleitung

Stand for Log Splitter 18-3570, 40-9122, 40-9511
Art.no. 40-9363
A
B
C
1. Close the bleed screw.
A
A
5. Fit the extensions to the legs on the other side
of the log splitter using the screws labelled A.
GREAT BRITAIN • CUSTOMER SERVICE tel. 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk
2. Turn the log splitter upside down, detach the wheels
and remove the plugs from the ends of the legs.
C
C
6. Fit the foot onto the ends of the legs using
screws labelled C. Turn the log splitter
the right way up.
B
A
A
3. First fit the extensions to the legs on the motor
side using the screws labelled A. Then screw
the cross member between the legs using
the screws labelled B (do not fully tighten
the screws yet).
7. Attach the handle.
B
4. Fit the wheels onto the legs. Adjust the wheels
so that they are parallel to each other and then
tighten screws A and B.
8. Check that all the screws and nuts are tightened.
9. Remember to open the bleed screw again
before operating the log splitter.