Listen To Radio; Tune To A Radio Station; Program Radio Stations Automatically; Program Radio Stations Manually - Philips DCM292 Benutzerhandbuch

5 Listen to radio

Tune to a radio station

1
Press TUNER to select FM.
2
Press and hold
seconds.
» SEARCH] (search) is displayed.
[
»
The radio tunes to a station with
strong reception automatically.
3
Repeat step 2 to tune to more stations.
To tune to a weak station, press
/
reception.
Program radio stations
automatically
You can program a maximum of 20 preset
radio stations (FM).
1
In the tuner mode, press and hold
PROG/CLOCK SET for more than 2
seconds to activate automatic program
mode.
» AUTO] (auto) is displayed.
[
»
All available stations are programmed
in the order of waveband reception
strength.
»
broadcast automatically.
Program radio stations
manually
You can program a maximum of 20 preset
radio stations (FM).
1
Tune to a radio station.
2
Press PROG/CLOCK SET to activate
program mode.
16 EN
/ for more than 2
» PROG] (program) is displayed.
[
3
Press / to allocate a number to this
radio station, then press PROG/CLOCK
SET
4
Repeat the above steps to program other
stations.
Tip
To overwrite a programmed station, store
another station in its place.

Select a preset radio station

1
In tuner mode, press / to select a
preset number.
You can also press the numeric buttons
to select a preset number directly.
Tip
Position the antenna as far as possible from
TV, VCR or other radiation source.
For optimal reception, fully extend and adjust
the position of the antenna.

FM stations with RDS

Radio Data System (RDS) is a service that
sends additional broadcast information along
with FM stations.
If you listen to a FM station with RDS signal,
"RDS" is displayed.
Display RDS information
1
For an FM station with RDS, press
RDS/DISPLAY repeatedly to display
various broadcast information.