Maintenance advice:
1. The sponge filter will become dusty over time. This is normal and will
not affect filter performance.
2. If the sponge filter is too dusty, it is suggested to remove it, clean it, and
then rinse it. Let the filter dry for 24 hours before reassembling it on the
vacuum.
3. This cleaning process should be performed every six months or when
suction performance appears to be significantly reduced.
IMPORTANT:
Please note that there is a safety valve inside the vacuum cleaner to prevent
the device from working with a high suction rate. If the vacuum is too high, the
safety valve will be activated. In this case, it can reduce the vacuum rate and
protect the engine from failure.
All filters should be checked regularly for any signs of damage, preferably
after each cleaning job. Filters should be replaced immediately if damaged.
Always unplug the vacuum from the electrical outlet when checking the filters.
Note:
The suction hole must be open, free of any obstruction at all times.
Otherwise, the motor will overheat and could be damaged.
Factsheet on Delegated Regulation (EU) No 665/2013
Model No.
Supply voltage
Rated input power
Disposal and environmental responsibility:
If you wish to dispose of your electrical appliance, either to replace it or because
you no longer use it, remember to take the environment into consideration.
Check with local authorities, as there are several environmentally friendly
recycling centres.
RAVC2225
220-240V~ 50/60Hz
800W
EN-14