Piega PS 101 Bedienungsanleitung

User Manual
Terminal fields
2 3
Output Input
STATUS
6
8
IWERT
PIE
PS 101
HIGH PASS
The "HIGH PASS" switch allows filtering of the LINE
output 2 for the satellite high pass. You can select
60, 80, or 100 Hz, depending on the size of your
oudspeaker.
OUTPUT
Line output for the satellite with high pass filter.
INPUT
Line input
Stereo music signal input for subwoofer.
PIEGA SA
Bahnhofstrasse 29
CH-8810 Horgen, Switzerland
S V'/ ITZEFR
4
HIGH LEVEL INPUT
LFE
ODR
7
CROSSOVER
9
AUTO cm
GA
wm,piega.ch
Low frequency effect input
This input bypasses the internal low-pass filtering.
That means that the c oss-over
active.
This input should be used only with a
corresponding subwoofer output (AV receiver sub
outpu
G
HIGH-LEVEL INPUT
These terminals for connecting amplified musc
signals allow loudspeaker cables to be used with
and without banana plugs.
LEVEL
Use this knob to control
CROSSOVER
Use this knob to set the subwoofer upward limit
frequency.
PHASE
Use this switch to set the subwoofer to "In phase"
or "Out of phase". Depending on the type of
loudspeaker used, there is ather phase
cancellation (less keynote) or phase correctness
(normal keynote) between the subwoofer and
loudspeaker at the O setting.
AUTO ON
Use this switch to activate the standby automatic
mode so that the subwoofer
automatically when a signal is received and then
back off when the signal ends. In the ON position,
the subwoofer remains
www.facebook.com/PiegaSwitzerland
function 7 is not
the subwoofer volume.
switches on
on.