Unpacking The Appliance; Electric Connection - BOMANN BQ 1240 N CB Bedienungsanleitung

replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental capa-
bilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a
safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
unless they are older 8 years and supervised.
• Keep the appliance and its cord out of reach of children less than
8 years.
Overview of the Components /
Delivery Scope
1 Grill pan
2 Grill grid
3 Heating element with control unit
4 Control lamp
5 Switch
6 Housing

Unpacking the Appliance

1. Unpack the appliance.
2. Remove all packaging materials such as foils, filling
material, cable ties and cardboard packaging.
3. Check the scope of delivery.
4. If the contents of the packaging are incomplete or display
obvious damage, do not operate the appliance. Return
promptly to the dealer.
NOTE:
There may still be dust or production remains on the
appliance. We recommend that you clean the appliance as
described under "Cleaning".
Installation
Please refer to the illustrations.
1. Place the grill pan into the housing.
2. Pour 1.8 litre of cold water into the grill pan up to the
"MAX" mark. A "MAX" mark can be found on the back
section of the grill pan.
32
BQ1240NCB_IM_new3
CAUTION:
• Always grill with water to avoid overheating.
• Do not fill with water above the "MAX" mark in order
not the damage the heating element.
3. Fit the heating element with the control unit into the
housing. Press gently until it audibly clicks into place.
NOTE:
The control unit is equipped with a safety switch. It prevents
operation of the heating element outside the housing.
Check that the control unit is properly fitted in the housing.

Electric Connection

1. Be sure the voltage of the appliance (rating plate) is in
accordance with the mains voltage.
2. Connect the mains plug to a properly installed shockproof
socket only.
Connected Load
The appliance is intended for a maximum power intake of
2000 W. This connected load recommends a separate input
lead secured with a 16 amp protected switch.
CAUTION: Overload!
• When using extension cords, these should have a cable
cross-section of at least 1.5 mm².
• Do not use gang plugs, because the appliance is too
powerful.
20.10.16