Error Codes - Pro -95 Gebrauchsanweisung

8
Technical maintenance
In order to provide the best functioning of the device, it is necessary to comply with the
following simple requirements:
Switch off the device, when not in use
Use protective cover, when not in use
Clean the hopper and stacker with a clean dry cloth. Sensors can cause errors when
dirty.
It is recommended to carry out preventive measures, including partial disassembling of
the counter each 30 days by an engineer in the service center.
Error
code
1.Halved banknote detected
HAF
2. Left or right sensor failure
CHn
Chained note detected
DbL
Double banknote detected
1. Banknote with different width
detected.
dd
2. Wrong banknote position.
CF1
Suspicious note detected by UV
Reason Solution
1. Remove the banknotes from the stacker, take
away the suspicious banknote (lying on the top),
and repeat the counting procedure
2. Contact the service center
1. Remove the banknotes from the stacker, and
repeat the counting procedure
2. Adjust the slot (Table 7.1.)
1. Remove the banknotes from the stacker, take
away the suspicious banknote (lying on the top)
and repeat the counting procedure
2. Adjust the slot, see Table 7.1.
3. Set lower sensitivity level, (see Table 7.2.3.)
1. Remove the banknotes from the stacker, take
away the suspicious banknote (lying on the top),
and repeat the counting procedure
2. Set the sensitivity level lower, (see Table
7.2.2.)
Remove the banknotes from the stacker, take
away the suspicious banknote (lying on the top),
and repeat the counting procedure

Error codes

23