Moza CRP Racing Pedals Benutzerhandbuch Seite 4

Insert the interface of the throttle line into the throttle interface found in the control module
at the bottom of the brake. Connect the clutch line to the clutch interface in the control
module, connect the elbow type-B end of the USB line to the USB interface in the control
module, and connect the other end to the PC. For the base with a pedal interface, it can also
be connected to the base through dual RJ45 data cable.
The working status of CRP Pedal can be viewed in the MOZA Pit House. If the device is still
grey or there is no response after stepping on it, please unplug the USB interface at the PC
end, close the MOZA Pit House, reconnect the USB interface, and reopen the MOZA Pit
House.
Important parameters, such as start, end, and travel of the pedal can be set in MOZA Pit
House.
Pedal Spacing Adjustment
Adjust the pedal forward or backwards. Use the included screws to secure the pedal once
the correct position has been found.
4