SIXTOL ROOF RACK FIX 1 Montageanleitung Seite 10

EN
NOTICE
CONSTRUCTION:
1. Please read the attached instruction manual carefully before using the product and keep it in a safe
place for future reference. After unpacking the product, check the parts list. Before fixing to the vehicle,
make sure that all parts are completely assembled according to the instructions for use.
2. Before each use of the crossbars, clean the roof of the vehicle and all parts that come into contact with
it.
3. During assembly, follow the instructions in the correct order of individual steps, i.e. 1, 2, 3, etc.
4. If the instructions do not specify specific distances for placing the crossbars, try to keep a minimum
distance of 700 mm between them.
5. When transporting large loads, the distance between the crossbars must not be less than 600 mm.
6. After each installation of the crossbars on the roof of the vehicle, make sure that they are firmly
attached. Perform a tension and compression test against each crossbars as well as against the
individual points of attachment to the roof. If any part of the crossbar moves, it is necessary to fix it
better. This test needs to be done regularly.
7. Some types of sun visors and radio antennas cannot be used in combination with these crossbars.
8. These roof rails can be installed on vehicles with a glass roof, unless otherwise specified in the
installation instructions.
9. The manufacturer is not responsible for damage to property or lost items from the cargo, caused by
incorrect assembly or incorrect use of the product.
10. It is not allowed to make any modifications to the product.
11. If you have any questions about the use and limitations of this product, please contact your dealer.
Please read the user manual and warranty information carefully.
CARGO:
1. The maximum load capacity of the product, which is specified in the assembly instructions, must not
be exceeded. However, this limit is subject to the maximum permissible carrying capacity of the vehicle
stated by its manufacturer. Always follow the lower permissible load capacity.
Max. load capacity of the roof = weight of the crossbars + accessories fixed on the crossbars +
weight of the load
2. The load must not significantly exceed the width of the vehicle and should always be evenly distributed
on both crossbars, with the center of gravity as low as possible.
3. The maximum load capacity applies to both the moving and the parked vehicle.
4. If you are transporting two or more surfboards, do not place them on the crossbars next to each
other, but on top of each other.
5. If you are transporting surfboards or other long cargo, it must be secured in the front and rear of the
vehicle.
6. Skis must be transported with the tips facing the rear of the vehicle.
7. Before placing the load on the roof of the vehicle, remove all loose or removable parts from the load,
such as a child's bicycle seat, pump, fenders, etc.
8. The load must be thoroughly secured. It is not advisable to use "rubber bands" to secure the roof load.
9. Check the safe securing of the load after traveling a short distance and then at regular intervals. If
necessary, tighten the fastening straps.
NOTE: Always check that the load is securely and correctly secured!
9