AmazonBasics B079LL22TC Montageanleitung Seite 7

• Mount the grab bar using a Philips screw driver. Ensure that the screws are tightly fastened into
a wood stud.
• Slide the grab bar covers overtop the mounting plates and snap them into place. If desired,
apply Silicon sealant or caulk to the backside of grab bar covers to prevent water infiltration.
Safety Information
Follow instructions along with line drawings in the AmazonBasics installation guide.
H-187948-AmazonBasics-Bathroom Handicap Grab Bar-IM-V03 (GLO).indb 7
Step 5:
Mount Grab Bar
• WARNING: To reduce the risk of injury, thoroughly read and understand all safety
information and instructions provided in this manual. If you do not understand
any of the safety information or installation instructions contact a professional for
assistance before attempting to install.
• WARNING: Install in accordance with these instructions only. Do not attempt to
modify or alter this product. After installation, check your grab bar periodically to
ensure all screws are tight. Retighten if loose.
• IMPORTANT: Mount the grab bar(s) to a secure surface. The manufacture will
not accept responsibility for any injury or any damages cause by the lack of wall
strength or improper installation.
• WARNING: All screws must be mounted directly and firmly into a wood stud.
Locate the middle of the stud by using a stud finder or other stud finding
method (Studs are usually 16" on center).
7
3/9/18 10:13 A