Corioliss C-EXTREME Bedienungsanleitung Seite 6

Operating instructions
EN
1
1.
2.
3.
4.
Operation
1. Plug your Corioliss into the power supply. At this point a POWER connection light comes
on. The iron switches on by default at the last set temperature (170º white light - 190º green
light - 230º red light).
2. To unlock the opening of the plates, slide the tab on the attached cable cylinder upwards.
3. Press the ON/OFF button to raise or lower the temperature. The temperature range
indicator light will come on.
4. The blue light indicates that the ion generator is operating.
5. Switch off your Corioliss using the ON/OFF button. Then unplug your Corioliss from the
mains and leave it in a safe place to cool down.
This tool is not only attractive for you, but also for children. Make sure you
always store it properly, keeping it out of reach, particularly during use and
while it is cooling down.
Failure to operate
In the unlikely event that your Corioliss product does not operate correctly, check that the
Corioliss product and mains power supply are switched on, and that power is available.
Your Corioliss styler is a product designed to work at a high level. If while using it the device
has gone through strong variations in the electrical power supply, can go into security mode
to prevent possible damage.
Therefore, in the unlikely event that your Corioliss product does not operate correctly,
check that the Corioliss product and mains power supply are switched on and that power is
available. If the product stops working, follow these steps:
1. Turn off the styler.
2. Unplug the styler from the main power supply.
3. Wait for a few seconds and plug the device again into the main power supply.
4. Turn on the styler.
5. In the case of any repeated faults or problems, please contact Corioliss Service Center.
6
2
3
Plates
Ion indicator
Power ON/OFF key
Power cord
4