Burchda RX20 Benutzerhandbuch Seite 4

1. Install handlebar riser 2. Adjust the nut position
4. Adjust the center position of the 5. Tighten the left and right nuts as
tire so that the positions on both shown
sides are the same.
7. Install the fender bracket screws
8. Take out the pedal with the letters
"R" and "L", align it with the crank
hole and lock it with a wrench
3. Install the front fork on the front
wheel bearing
6. Install the lights and fenders, and
connect the light wires (note that
the arrows at both ends of the
wiring correspond)
Battery disassembly and assembly
1. Turn off battery power 2. Turn the key counterclockwise 3. Lift the top of the battery up and
remove the battery