Installing/Removing Main Memory - Fujitsu D2703 Handbuch

6 - English

Installing/removing main memory

Technical data
Technology
Total size
Module size
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
You may use only unbuffered 1.8 V memory modules without ECC.
DDR2-memory modules must meet the PC2-5300U or PC2-6400U specification.
The mainboard D2703-A has one main memory slot. The mainboard D2703-S has two.
Maximum system performance is achieved when the same memory size is
used in Channel A and Channel B (only D2703-S).
With a memory configuration of 4 GB the visible and usable main memory can
be reduced to 3.5 GB (depending on the system configuration).
slot 2
slot 1
The installation/removal is described in the "Basic information on mainboard" manual.
20
DDR2 667 / DDR2 800 unbuffered SO-DIMM modules 200 pin; 1.8 V;
64 Bit, no ECC
128 MBytes to 4 GBytes DDR2 (D2703-S)128 MBytes to 2 GBytes
DDR2 (D2703-A)
128, 256, 512, 1024 or 2048 MBytes per module
Channel B
Channel A
Installing/removing main memory
Fujitsu Technology Solutions