Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Function and device overview
4 Function and device
overview
With the Homematic IP Valve Drive –
motorised you can control the valve
position and thus regulate the water
flow rate to regulate the room tempe-
rature.
The valve has to be operated in con-
nection with a Homematic IP Floor
Heating Actuator – 12 channels, moto-
rised (HmIP-FALMOT-C12).
Device overview:
(A) Electronic unit (thermostat)
(B) Display
(C) System button (pairing button and
LED)
A
B
C
Figure 1
5 Installation
The valve drive can be installed in
any position (e.g. upside down).
For installation, no tools are requi-
red.
To install the valve drive, proceed as
follows:
• Make sure if the valve drive fits to
the thread size M30 x 1.5 mm. We
recommend to use the valve tem-
plate available for download in the
download area of
www.homematic-ip.com. If the
valve drive differs, you will need a
corresponding adapter.
• Attach the supplied valve adapter
(VA 80) to the valve.
2
Figure 2
• Attach the valve drive to the adap-
ter. Make sure that the valve drive
engages properly.
Figure 3
1
click
10
Werbung
