Copyright And Trademark Notices; Ce Statement; Fcc Statement - level 1 BLH-1100 Schnellinstallationsanleitung

English

Copyright and Trademark Notices

All other products are trademarks and registered trademarks of their respective owners and hereby
recognized as such. All specifications are subject to change without prior notice.

CE Statement

This device has been tested and found to comply with the requirement set up in the council
directive on the approximation of the law of member states relating to EMC Directive 89/336/EEC,
Low Voltage Directive 73/23/EEC and R&TTE Directive 99/5/EC.

FCC Statement

This device complies with Part 15 of the FCC rules. Operation is subject with the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
The relative output power is far below the FCC Radio frequency exposure limits. Nevertheless, this
device should be used in such a manner that the potential for human contact during normal
operation is minimized.
Warning: Changes or modifications made to this equipment not expressly approved by the
manufacturer. May void the FCC authorization to operate this equipment.
Important! Please note the following:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
14 15
English