North Light NL-CO1606 Kurzanleitung

Satellite Ceiling Light
Please read the entire instruction manual before using the product
and then save it for future reference. We reserve the right for
any errors in text or images and any necessary changes made
to technical data. In the event of technical problems or other
queries, please contact our Customer Services.
Safety
• All light fittings must be installed in accordance with current
safety regulations to prevent life-threatening accidents.
Installation should only be performed by those with a good
knowledge of electrical wiring.
• Contact a registered competent person or qualified
electrician if you do not possess the required knowledge to
perform such an installation on your own.
• Follow the instructions carefully and keep them for future
reference.
• The ceiling light is only meant to be used in clean, dry
indoor environments. Do not expose the light fitting to
water, moisture or other liquids.
• Never attempt to repair or modify the ceiling light in any way.
• Only use a dry cloth to wipe the ceiling light clean when needed.
• The bulbs can become very hot during use. Let them cool
completely before changing.
The product is only intended for indoor use.
Installation
Note: If you are at all unsure about proper installation
procedures, seek the advice of someone with the requisite
knowledge to help you perform such an installation or consult
a qualified electrician.
The light fitting needs to be earthed (class I).
GREAT BRITAIN • CUSTOMER SERVICE
tel. 020 8247 9300 e-mail: customerservice@clasohlson.co.uk internet: www.clasohlson.co.uk
Art.no 36-6224-1 Model NL-CO1606
36-6224-2
Warning: Before beginning any electrical
installation always disconnect the power
to the circuit you are working on,
either by turning off the main circuit
breaker or by removing the fuse from
the consumer unit. Make sure that
there are no obstructing cables or pipes
behind the wall/ceiling area where you
have planned to drill.
Connecting the ceiling light to a power
point using a pre-mounted ceiling hook
1. Obtain a plug cable and connect its wires to the lamp's
terminal block.
2. Connect the plug to the power point and hang up
the ceiling light onto the ceiling hook.
3. Push the ceiling cup flush against the ceiling and tighten
the ceiling cup set screw securely as shown in the illustration.
4. Screw in the bulbs (3 × E27, max 40 W).
5. Turn the power back on.
NL-CO1605
Wired installation without a socket or
a pre-mounted ceiling hook
1. Use a suitable ceiling hook and screw it securely into
the ceiling at an appropriate mounting point.
2. Connect the electrical supply cable to the lamp's
terminal block. Hang up the lamp onto the ceiling hook.
Push the ceiling cup flush against the ceiling and tighten
the ceiling cup set screw securely.
3. Screw in the bulbs (3 × E27, max 40 W).
4. Turn the power back on.
Responsible disposal
This symbol indicates that this product should
not be disposed of with general household
waste. This applies throughout the entire EU. In
order to prevent any harm to the environment
or health hazards caused by incorrect waste
disposal, the product must be handed in for
recycling so that the material can be disposed
of in a responsible manner. When recycling
your product, take it to your local collection
facility or contact the place of purchase. They
will ensure that the product is disposed of in
an environmentally sound manner.
Specifications
Power supply 220–240 V, 50/60 Hz
Light bulbs 3 × E27, max 40 W
(sold separately)
ENGLISH