Coltech 51050X10 Bedienungsanleitung

Flush Mount Switch Receiver
Art.no 36-6032 Model 51050X10
Please read the entire instruction manual before using the product and
then save it for future reference. We reserve the right for any errors in
text or images and any necessary changes made to technical data.
In the event of technical problems or other queries, please contact our
Customer Services.
Installation
Note:
Electrical installations should only be carried out by a qualified electrician.
Wiring to 230 V power supply
Connecting a light
GREAT BRITAIN • CUSTOMER SERVICE tel. 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk
Pairing the receiver with a transmitter
1. Hold in the button
on the front of
the receiver for at
least 3 seconds and
then release it.
2. The LED inside
the button will start
to flash slowly.
The receiver is now
ready to be paired
with a transmitter.
3. Pair the receiver to the transmitter by following the instructions
accompanying the transmitter.
Note: The light can also be switched on/off manually by pressing
the button on the receiver.
Unpairing all paired transmitters
1. Hold in the button
on the front of
the receiver for
6 seconds until
the LED inside
the button starts to
flash quickly.
2. When the LED
stops flashing, all
the transmitters
which were paired
with it will have been
unpaired.
Unpairing one paired transmitter
1. Hold in the button on the front of the receiver which you want to
unpair the transmitter from for 3 seconds and then release it.
2. The LED inside the button will start to flash slowly. The receiver is
now ready to unpair from the transmitter.
3. Press in the [ OFF ]-button on the transmitter (make sure to choose
the correct [ OFF ]-button if the transmitter can connect to multiple
receivers). The transmitter will now unpair from the receiver.
Troubleshooting guide
The receiver is not • Has the receiver been paired with
working, the LED a transmitter as described above?
is not lit. Try pairing them again.
• Check that the light is properly plugged
into the receiver and that it is switched on
and not faulty.
• Try plugging the light into another electrical
outlet to make sure that it works.
• Is there electricity in the outlet the receiver
is plugged into?
Responsible disposal
This symbol indicates that this product should not be
disposed of with general household waste. This applies
throughout the entire EU. In order to prevent any
harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed
in for recycling so that the material can be disposed of
in a responsible manner. When recycling your product,
take it to your local collection facility or contact the
place of purchase. They will ensure that the product is
disposed of in an environmentally sound manner.
Specifications
Rated voltage 220–240 V AC, 50 Hz
Frequency 433.92 MHz
Max range 25 m
Load (resistive bulb) 0–1000 W
Load (inductive) 0–166 W