Operation; Switching Off - Cotech 18-4370 Bedienungsanleitung

Charging
Temperature range for charging and storing the battery: 0–40 ºC.
1. Depress the battery release catch and slide the battery out of the tool.
2. Insert the battery into the charger.
3. Plug the charger's mains adaptor into a wall socket.
4. The LED on the mains adaptor will shine red during charging and green when the battery is charged.
The LED will also shine green if the charger is connected to the mains without a battery inserted.
5. After charging, replace the battery into the tool and push it in until it clicks.
Note
• The lithium-ion battery has a built-in electronic deep discharge protection which means that it will not work
at reduced power. It works at full power until the protection switches off the current because the battery
needs charging. The trimmer will then switch off automatically. Do not continue to press the on/off switch
after the trimmer has automatically switched off as this can damage the battery.
• The battery also has a built-in electronic overload protection. If the trimmer is put under too much pressure,
the electronics cut off the trimmer. If this happens, release the on/off switch, wait a few seconds and then
continue working.
• The lithium-ion battery has no memory which means that it can be charged at any time regardless
of battery level.
• Charge the battery for at least 6 hours the first and second time it is charged.
• For long-term storage the battery should be fully charged at least every 6 months.

Operation

Regularly spray the blades with maintenance spray for best results.
Switching on
1
1. Press and hold in the on/off
switch on the rear handle (7).

Switching off

Release the front or rear on/off switch.
2
3
1
2
2. Pull the front handle switch
lock (5) outwards and
upwards.
3
6
1
2
3
3. Press in the front handle on/
off switch (4).