FLINQ Solar Light Yora 2-pack Handbuch Seite 3

EN Manual
Installation
Install on soft surfaces such as grass or sand
1 Choose the desired height
You can adjust the height of the lamp by
using a plastic connector between the
aluminum poles.
Install on hard surfaces such as stone tiles or wood
1 Choose the desired height
You can adjust the height of the lamp by
using a plastic connector between the
aluminum poles.
4
2 Fit ground pin
Use the ground pin to place the lamp in a
soft surface
2 Fit the plastic base
Use the plastic base to connect the lamp to
hard surfaces. Use plugs and screws to attach
the lamp to the surface
Use the lamp
Long pressing 3seconds to turn it on ,short pressing switch to change different modes:
Mode Name
Mode 1 White light
Mode 2 Warm light
Mode 3 White light+Warm light
Off Off
FlinQ Solar Light Yora 2-pack
Feature
Automatically charge during day
and light up at night.(Keep Ligh-
ting time more than 8 Hours
after full charge, until the battery
voltage is lower than the low
voltage protection)
Turn the light off
5